WOZOM had been manufacturing various kinds of machinery spare parts using casting process since 1993, after a few years, it just gradually moved to produce construction bucket teeth and adapters and began global sales. During above ten years' development, WOZOM has become a professional company dealing with production, sales and service of construction working tools, accessories and agricultural working tools ,accessories. The quantity of accessories model number adds up to ten thousand, which is still arising and improving. WOZOM products have been widely used in all kinds of construction, mining and agricultural machines, to meet demands of different working conditions of building , road ,mining, forestry, harvest, plough and seeding.
High pressure abrasive water jet cutting is the preferred cutting method. Thermal cutting using an oxyacetylene torch, arc-air or plasma is not recommended due to high localized heat input and high risk of cracking and delamination.
For GET no greater than 25mm section thickness, cutting by abrasive disc is an accepted practice.
CAUTION.Extreme care must be taken when cutting to minimise local pre-heating or cracks and delamination may occur.
Cutting Procedure<25mm Section Thickness
1.Secure the GET piece to be cut in a vice or clamp.
2.Notch the backing plate as shown in Figure1.
3.Notch the White Iron a minimum of 3mm deep opposite the notch in the backing plate,as per Figure2.
4.Wrap the GET with a rag and carefully hit using a soft faced hammer. The piece should break cleanly at the notch.
Note:The deeper the notch in the White Iron, the cleaner the break.